—kg / piece
Calculated from the net drawing area
MM / PROJECT STUDIOCONCEPT
Untitled concept
Bring the drawing, the numbers and the conversation together.
Concept
This is an editable, unsaved concept. to save privately and work with your team.
0kg total
Add your first material line
—%
Finished length / purchased stock
0 / 5checked
Define the remaining project details
DESIGN WORKSPACE
Your concept, in view.
PROJECT DIRECTION
The next step.
- Client / organisation
- To be confirmed
- Application
- To be defined
- Target date
- Not set
- Last saved
- Unsaved concept
PARAMETRIC CONTROLS
Define the geometry.
Hole pattern
4 holesSelect a hole to edit its coordinates, or place a new one on the canvas. Origin: bottom left.
Concept geometry for coordination and review.
This editor creates 2D concept outlines and circular holes. It does not calculate structural capacity, connection performance or manufacturing tolerances. Review the geometry and specification before manufacture.
| Item / description | Profile & dimensions | Quantity | kg / piece | Total kg | Actions |
|---|---|---|---|---|---|
| SCHEDULE TOTAL | 0 | 0.00 | |||
Every quantity starts with a detail.
Add plate, flat bar, round bar or a hollow section. The schedule calculates each line from its dimensions and density.
Use the concept as a starting point.
Add the drawing’s bounding plate as a material line. Gross plate mass excludes hole deductions; the design canvas shows the separate net geometry mass.
Make the assumptions visible.
Mass = ideal volume × density. Hollow sections use square corners. Coatings, fixings, corner radii and tolerances are excluded. Density presets are editable.
View calculation references ↗STOCK & REQUIREMENTS
Plan the cut.
Finished lengths
Best-fit descending groups mixed lengths. One kerf is counted per separated part; a final cut is omitted when the last part reaches the usable stock end.
CUTTING LAYOUT
Understand every length.
Finished partsKerf / trimOffcut
A planning heuristic, not a guarantee of the fewest possible stock lengths. Each batch assumes the same profile and stock length. Check clamps, defects, trim cuts and the actual cutting process.
COORDINATION STATUS
Define the next decision.
Stages describe the project workflow. “Coordinated” does not imply engineering approval or certification.
Review checklist
SAVED RECORD
Revision history.
CLIENT & TEAM CONVERSATION
0 openKeep the review connected.
BRANDED PROJECT REPORT
Make the detail readable.
Ready to take forward.
A clear brief for the next conversation.
Carry a concise summary to the enquiry form. Review the message before choosing to submit it.
WHITE-LABEL PRESENTATION
Put your brand on the work.
Brand settings are saved with this project and used in its reports and drawing accents. A dedicated domain or separately deployed client portal is a consultation scope.
One project. One consistent presentation.
Use the same name, accent, tagline and contact details across the workspace’s drawing preview and project report.